AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 153

System Renumbering
Console Display/Instructions
9 Return to the System Programming menu.
Exit Exit
Select two times.
Block Renumbering
Use this procedure to assign extension numbers to a group of extensions,
accessories, or lines. Both the original numbers and the numbers they are being
changed to must be sequentially numbered.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
!
CAUTION:
Select Exit on the console or
renumbering extensions. If you press Home , extensions may remain in the
forced idle condition (indicated when the LED next to each DSS button is
on). To restore extensions to their normal operating state, restart the
system.
Summary: Block Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Additional Information
#
on the PC when you have finished
System manager
All
System idle
Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Not applicable
Old and new extension numbers
Yes
Yes
SysRenumber Block
Enter
first group member
Enter
member Dial new beginning no.
Exit Exit
Select type of group
member Type no. of last group member
Type new beginning no.
Common Administrative Procedures
Select type of group
Dial no. of last group
Enter
Type no. of first group
PC
##
Dial no. of
Exit
3–17