AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 102

Using SPM
5 Type the new filename and press
You can specify a drive letter with the filename but no path information.
6 Verify that the filename chosen does not already exist.
The following screen appears only if the filename chosen already exists.
Continue with Step 7 if this screen does not appear.
" "
7 Observe the backup status screen.
SPM indicates the status of the backup by displaying the number of the last
block received ( NN ). Line 2 of the display screen shows the estimated number of
blocks to be sent from the control unit ( NNN - NNNN ). This line is blank if you are
backing up from Release 1.0.
If you abort the backup, the partial backup file is deleted to prevent restoration
from a corrupted file and you see the screen shown in Step 8.
When the backup is complete, you see the screen shown in Step 9.
8 To abort the backup press
2–24
Programming with SPM
4
.
If you are working from the floppy drive,
appears on the screen.
-
Press to abort the backup. Go to
Step 1 to create a different backup file.
?
Press to continue. Go to Step 7.
filename = the backup filename specified
in Step 5
-
to return to the SPM Main Menu.