AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 362

Memory Card
NOTE:
If the system performs a System Erase (frigid start), all programming is set to the
default values. If a previous backup file is available, perform a restore. If not, the
system must be reprogrammed. See "Restore" in Chapter 4 for information about
the system restore procedure.
Also see "Backup Messages" for information about errors that may occur during
the backup procedure.
Summary: Backup
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure Insert memory card
PC Procedure
Procedure: Backup
Console Display/Instructions
1 Insert the memory card into the PCMCIA interface slot on the processor module.
See Figure 3–5, "Inserting the Memory Card."
2 Select the System menu.
_
3–226
Common Administrative Procedures
System manager
All
Not required (No extensions are allowed to be in
programming mode except system programming console)
Form 1, System Planning
Not applicable
1- to 11-character filename
Yes
No
Select backup file Dial the new backup filename
Insert memory card
Type the new backup filename
Additional Information
Select backup file
PC