AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 37

Programming Procedures
Using Next
When you are programming a feature that can apply to a sequence of
extensions, lines/trunks or groups, the screen key
display.
the next number in the sequence. You can continue to press
programming the entire sequence. When the last number in the sequence
displays on the screen, press
entry and move to the next step of the procedure. Procedures that allow the use
of will direct you to the correct screen to continue programming as shown
in Step 6 in the example below below.
NOTE:
If you plan to take advantage of this key, remember to enter the lowest number
in the sequence at the first prompt.
Console Display/Instructions
5 Specify whether the operator receives the alert.
NNNN
_
_
6 Save your entry.
Select or
7 Return to the System Programming menu.
Select two times.
( on the PC) permits you to save your current entry and display
Additional Information
xxxx = operator entered in Step 1
Select
Use
Step 5.The next QCC operator will be displayed on
Line 1. After programming the last QCC operator
position, select enter and go to Step 7.
appears on the console
( or on the PC) to save the final
or
.
to program the next QCC position. Go to
Programming Basics
until you finish
PC
1–21