AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 184

QCC Optional Features
Console Display/Instructions
4 Specify the QCC operator extension.
5 Assign or remove the extension as a message center.
Enter Enter
Select or
Delete Delete
.
6 Return to the System Programming menu.
Exit
Exit
Select three times.
Extended (Directed) Call Completion
Use this procedure to specify one of the two basic options shown below for QCC
operator positions with a DSS only:
Automatic Completion. Allows one-touch call transfer; that is, calls are
transferred by touching only an extension button on the DSS. The
operator does not have to press the Release button.
Manual Completion. QCC operators must press the Release button to
direct a call using a DSS.
This option cannot be programmed for individual QCC operator positions. The
setting applies to all QCC operator positions.
Summary: Extended (Directed) Call Completion
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
3–48
Common Administrative Procedures
Additional Information
If no DSS is attached:
SP: "Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required.
On = extension is message center
position.
Flashing = extension is not message
center position.
Off = extension is not an operator position.
You may continue to assign or remove
extensions as a message center by
repeating Steps 4 and 5.
System manager
Hybrid/PBX
Not required
Form 6a, Optional Operator Features
Automatic Extended Completion
PC