AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 399

Lines and Trunks
Console Display/Instructions
6 Enter the port numbers that have ground-start or loop-start trunks connected.
400 and 408 ports: n = 1 to 4; 800 ports: n = 1 to 8.
7 Continue to assign trunk types or go to Step 8.
Next Next
Select .
8 Save your entry.
Enter Enter
Select .
9 Return to the System Programming menu.
Exit Exit
Select two times.
Outmode Signaling for Loop- or Ground-Start
Trunks
Use this procedure to identify either touch-tone signaling or rotary-dial signaling
for outgoing calls placed by using the specified loop- or ground-start trunk.
NOTE:
Since the factory setting is touch-tone, this procedure is not required if your
system has only touch-tone lines/trunks.
Summary: Outmode Signaling for Loop- or
Ground-Start Trunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
NN
**** = option name selected in Step 5
xx = slot number entered in Step 3
NOTE:
If you get the Trunk Busy message, wait
for an idle condition or exit system
programming and try again later.
Dial or type [ n ].
Return to Step 6. The next slot number
will be displayed on Line 1.
System manager
Loop-Start: All; Ground-Start: Hybrid/PBX only
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Touch-tone
Touch-tone, Rotary
No
Yes
Additional Information
Programming Procedures
PC
4–27