AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 159

System Operator Positions
Console Display/Instructions
4 Specify the QCC extension.
5 Assign or remove the QCC operator extension.
Select or
.
6 Indicate that you have finished entering all positions.
Select .
DLC Operator Positions
DLC operator positions can be assigned to the first and fifth extension jacks on
the first modules with digital or analog multiline extension jacks. A maximum of
eight DLC operator positions can be assigned. Any combination of operator
positions can be assigned as long as there are no more than four QCC operator
positions and no more than a total of eight operator positions.
Use this procedure to specify extensions that serve as central answering
positions for all incoming calls, for Call Management Systems (CMSs) connected
to operator extension jacks, or as calling group supervisor extensions. (You do
not need to use this procedure in a Key or Behind Switch system unless you
have more than one DLC position.) For a new system, remove the factory-set
DLC operator position assignment for any telephone not used as an operator
position.
Lines and trunks are assigned on individual buttons.
Additional Information
If no DSS is attached:
SP: "Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 6.
On = extension is currently assigned
as a QCC position.
Flashing = extension can be assigned
as a QCC position.
Off = extension cannot be assigned
as a QCC position.
You may continue to assign or remove
QCC operator positions by repeating
Steps 4 and 5.
The session is terminated and the system
restarts. You must enter system
programming again to continue.
Common Administrative Procedures
PC
Û
3–23