AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 197

Telephones
Console Display/Instructions
4 Save your entry.
Enter Enter
Select .
5 Assign the extension.
_
_
_
_
l l
Single Line/Trunk Procedure
1 Specify entry mode.
Entry Mode
Entry Mode
Select
2 Enter the line or trunk number.
NNNN
3 Assign or remove the specified line/trunk number.
Enter Enter
Select or
Delete
Delete
.
4 Assign a single line/trunk to the next extension or go to Step 5.
Next Next
Select
5 Return to the System Programming menu.
Exit Exit
Select two times.
If you get the Station Busy message, wait
for an idle condition or exit system
programming and try again later.
xxxx = extension number entered in Step 3
_
For a single line/trunk, go to
Single Line/Trunk Procedure.
For a block of lines, go to
Block Procedure.
.
xxxx = extension number entered
in Step 3
Dial or type [ nnn ].
You may continue to assign or remove
lines/trunks by repeating Steps 2 and 3.
Return to Step 2 to continue programming. The
next extension will be displayed on Line 1.
Additional Information
Common Administrative Procedures
PC
3–61