AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 198

Telephones
Block Procedure
Console Display/Instructions
1 Specify the block of 20 lines associated with 20 buttons on the system
programming console.
Select
.
2 Assign or remove the line/trunk to or from the line button.
3 Save your entry.
Select .
4 Return to the System Programming menu.
Select two times.
Copy Line/Trunk Assignments
Use this procedure to copy outside line/trunk button assignments, pool dial-out
code restrictions (Hybrid/PBX only), and (for operator positions only) Night
Service information from one extension to another extension or block of
extensions with identical requirements.
If you are copying assignments to a block of extensions and one of the
extensions in the block is in use, the display shows the
message. Copying for the rest of the extensions in the block is delayed until
the busy extension becomes idle. The number of the busy extension is not
shown. If a DSS is attached, the LED associated with the busy extension is on. If
you exit instead of waiting for the busy extension to become idle, copying for the
rest of the extensions is canceled; however, the assignments that have already
been copied are not canceled.
3–62
Common Administrative Procedures
Additional Information
Toggle the green LEDs next to each
line button on or off as required.
On = line/trunk or pool assigned to extension.
Off = line/trunk or pool not assigned to extension.
For Hybrid/PBX only:
The red LED indicates:
On = trunk assigned to pool.
Off = trunk not assigned to pool.
PC