Attaching Scsi And Power Cables; Figure 4 Attaching Scsi And Power Cables - Freecom SUPERLOADER3 LTO2-HH Manual

Attaching SCSI and
Power Cables 2
Figure 4 Attaching
SCSI and Power
Cables
1
1
2
3
If the supplied SCSI cable does not fit the connector on your SCSI host
adapter, you either have an incompatible SCSI host adapter or you need
to purchase a cable adapter. Contact your service representative or your
SCSI host adapter manufacturer for information.
1 Attach the terminator to the remaining SCSI connector on the back
panel of the autoloader (if the autoloader is the last or only device on
the SCSI bus). Otherwise, attach the cable to the next device on the
SCSI bus. Make sure that the last device on the SCSI bus is properly
terminated.
2 Attach the female connector of the power cable to the power
connector on the back panel of the autoloader.
3 Plug in the power cable to the nearest properly grounded power
outlet.
4 Plug in the host server or workstation and all attached devices.
SuperLoader 3 Autoloader User's Guide
Chapter 2 Installation and Configuration
Connecting the SCSI and Power Cables
3
2
Ethernet cable
SCSI cable
SCSI terminator
17