Table of Contents
Advertisement
Chapter 7 Customer Replaceable Units (CRUs)
Rack Mounting the Autoloader
General
Preparation for
Rack Mount
Installation
7
Stationary Rack
Mount Installation
7
88
Take the following general safety steps before beginning either rack
mount installation.
1 Lower the cabinet feet.
2 Extend the cabinet anti-tip device, if available.
3 Ensure that the cabinet and all rack mounted equipment have a
reliable ground connection.
4 Verify that the total current of all rack mounted components
(including the SuperLoader) will not exceed the current rating of the
power distribution unit or outlet receptacles.
5 Secure the help of at least one other person. At least two people are
required to safely install the SuperLoader into a rack cabinet.
Warning:
Failure to take these safety steps may result in
personal injury or equipment damage.
Do not remove the top cover of the autoloader during
Caution:
the installation process. Removing the top cover could
result in damage to the autoloader.
This section describes the steps for attaching the autoloader directly to
the rails of a rack.
1 Make sure you have the following tools and parts:
•
#2 PHILLIPS
•
Level
•
The following autoloader accessory kit parts (see
•
Four autoloader brackets (two long and two short to
accommodate different rack depths)
Use the short autoloader brackets (74-60604-03) unless the
distance from the front mounting rail to the rear mounting
rail is less than 30.25 in. (76.84 cm).
•
Two support brackets (74-60605-01)
•
Eight 10-32 x 1/4 inch button head screws for the support
brackets (four per support bracket)
SuperLoader 3 Autoloader User's Guide
®
screwdriver
figure
11):
Advertisement
Table of Contents
