Table of Contents
Advertisement
Removing the
Autoloader from a
Rack
8
3 Remove the power, Ethernet, and SCSI cables, and any terminators
from the autoloader.
Note:
Do not ship these items if you are returning the autoloader
to the factory.
To remove the autoloader from a rack:
1 Loosen the four screws that connect the two support brackets to the
two autoloader brackets.
2 Loosen the four screws on the front of the autoloader that attach the
two front tabs (support brackets) to the front rails. Do not remove the
screws completely at this time.
3 Remove the four screws at the back of the autoloader that connect the
support brackets (two screws per bracket) to the autoloader brackets.
4 While supporting the front of the autoloader, remove the four front
screws.
Caution:
Injury may occur if the unit is not supported when
you remove the front screws. The screws are holding
up the front of the unit.
5 Using two people, or an appropriately rated mechanical lift, remove
the autoloader from the rack by sliding the autoloader out and
supporting it from the bottom. The person handling the back of the
unit must depress the locking tab on the support bracket while
sliding the unit forward.
6 Loosen the four screws and remove the autoloader brackets from the
back of the autoloader.
7 Place the autoloader into the original packaging box. If you no longer
have the original packaging, contact your service representative to
purchase the packaging kit.
SuperLoader 3 Autoloader User's Guide
Chapter 8 Troubleshooting
Returning the Autoloader for Service
113
Advertisement
Table of Contents
