Setting The Snmp Server - Freecom SUPERLOADER3 LTO2-HH Manual

Setting the SNMP
Server 5
3 From the
Ethernet
. The cursor automatically appears at the first digit.
Enter
4 At each position of the gateway address, use the up and down arrows
to change the value of each digit. Press
the next digit.
When you have advanced through all of the digits of the gateway
address, the autoloader displays
Note: If you make a mistake, press
digit you want to change.
5 Press .
Enter New Gateway is xxx.xxx.xxx
not need to reboot the autoloader.
6 Press or
Escape Enter
An SNMP server monitors a network by processing reporting activity in
each network device (hub, router, bridge, and so on). The server uses this
information to define what is obtainable from each device and what can
be controlled (turned off, on, and so on).
To set an SNMP server:
1 From the main menu, scroll to
2 From the
Configuration
3 From the
Ethernet
. The cursor automatically appears at the first digit.
Enter
4 At each position of the SNMP server address, use the up and down
arrows to change the value of each digit. Press
cursor to the next digit.
When you have advanced through all of the digits of the SNMP
server address, the autoloader displays
Note: If you make a mistake, press
digit you want to change.
5 Press .
Enter New SNMP Server xxx.xxx.xxx
not need to reboot the autoloader.
SuperLoader 3 Autoloader User's Guide
submenu, scroll to
Set Gateway
Enter
Enter to save.
Escape
appears on the LCD. You do
to return to the Ethernet submenu.
Configuration
menu, scroll to
Ethernet
submenu, scroll to
Set SNMP Server
Escape
Chapter 5 Administration
Configuring the Autoloader
, and then press
to advance the cursor to
to backspace to the
, and then press
Enter
, and then press
, and then press
to advance the
Enter
Enter to save.
to backspace to the
appears on the LCD. You do
.
.
Enter
65