Diagnostics; Identification; Performing A System Reset - Freecom SUPERLOADER3 LTO2-HH Manual

Diagnostics

4

Identification

4
Performing a
System Reset 4
To view the various diagnostic options:
1 From any page, click the
displays.
2 In the
Diagnostics
run from the
Test
3 Specify a loop count, if desired.
4 Click .
submit
5 While the test is running, you can view the status of the test. From
View Diagnostic Test Progress
A separate screen indicates which test is running and the current
status of the diagnostic test.
6 To refresh the status information, click
and then click
View Status
You can use the
Identification
LCD backlight to flash for a specified number of seconds.This can be
helpful in identifying the location of the autoloader in an equipment
room.
1 From any page, click the
displays.
2 Under
Identification
field.
3 Click . The LCD backlight flashes on the autoloader for the
Identify
specified number of seconds.
You will use
System Reset
magazine changes, and IP address changes. A system reset will take at
least three minutes if there is a tape in the drive, or approximately 30
seconds otherwise. To perform a system reset:
1 From any page, click the
displays.
2 Under the
System Reset
SuperLoader 3 Autoloader User's Guide
Chapter 4 On-board Remote Management
heading. The
Diagnostics
section, select the diagnostic test that you want to
drop-down menu.
, click
View Status
View Diagnostic Test Progress
again.
feature of the autoloader by requesting the
heading. The
Diagnostics
, enter the number of seconds in the
when making SCSI ID changes, mode changes,
heading. The
Diagnostics
section, click
System Reset
Diagnostics Page
screen
Diagnostics
.
,
screen
Diagnostics
Time (secs)
screen
Diagnostics
.
55