Chapter 5 Administration
Configuring the Autoloader
Setting the SCSI ID
5
Setting Ethernet
5
62
To configure the Quantum SuperLoader 3 autoloader, you must verify
the setup of the following:
•
SCSI ID(s). For the autoloader, there is a single SCSI ID.
•
Magazine(s).
•
Ethernet IP address (if you are not using DHCP).
•
SNMP server IP address only if SNMP is being used.
•
Time server IP address (or the time zone, date, and time, if
configuring manually)—only if a time server is being used.
•
Control mode.
•
Security option.
Each SCSI device attached to a server or workstation must have a unique
SCSI ID. For the SuperLoader 3 autoloader, you need one SCSI ID.
To set the SCSI ID:
1 If the main menu is not already visible, press
2 On the main menu, scroll to
3 On the
Configuration
4 Scroll to the number you want to set as the autoloader's SCSI ID, then
press
.
Enter
Cycle Power new SCSI ID
5 Press and hold the power button on the front panel until
Shutdown wait 60 sec
LCD, then the autoloader shuts off.
6 Press the power button again to power on the autoloader. The new
SCSI ID is now in effect.
Ethernet is the method used by the autoloader to access a network. With
an Ethernet connection, you can remotely access the autoloader over the
network. To use the Ethernet connection, you must define the following:
•
A dynamic or static IP address for the autoloader (required)
•
A subnet mask (required)
•
An IP gateway (optional)
SuperLoader 3 Autoloader User's Guide
Configuration
submenu, scroll to
SCSI ID
appears on the LCD.
appears on the LCD.
Power Off
.
Enter
and press
.
Enter
and press
.
Enter
System
appears on the