Table of Contents
Advertisement
•
POST
•
Diagnostic Tests from the Front Panel
•
On-board Remote Management Diagnostic Tests
The Power On Self Test (POST) and diagnostic tests are helpful tools for
testing the autoloader's functionality and for troubleshooting errors.
With the results from the POST and diagnostic tests, you can determine
how well the autoloader is working and locate any problems.
The Diagnostics section describes the POST and its various tests. This
section also explains how to perform diagnostic tests from the front panel
and On-board Remote Management.
Only use the
Note:
known to be idle and unavailable to host backup/restore
applications. Use of the
Remote Management should not be issued while the
autoloader is being used by host applications. The autoloader
will recognize when the drive or autoloader are executing host
commands and will respond appropriately to prevent
application failures. A
between host application commands may not be recognized
appropriately resulting in a failed application, such as a failed
backup/restore job.
SuperLoader 3 Autoloader User's Guide
on page 75
Diagnostics Commands
Diagnostic Commands
command being issued
Diagnostic
Chapter 6
Diagnostics
6
on page 78
when the autoloader is
from On-board
73
Advertisement
Table of Contents
