Table of Contents
Advertisement
Chapter 8 Troubleshooting
Checking for Errors
Packing the
Autoloader
8
Checking for Errors
114
Use the original packing material to pack the autoloader: the shipping
container, two foam insert packing pieces, the accessory kit box (or the
filler tube if your autoloader did not come with an accessory kit box), and
the antistatic bag. You will also need packing tape.
1 Place the antistatic bag over the autoloader.
2 Place one of the foam endcaps onto one side of the autoloader. Place
the second foam insert onto the other side of the autoloader and
make sure the pieces fit snugly onto the autoloader.
One end of the foam insert has a curved piece. This end of
Note:
the foam insert is designed to fit the front of the
autoloader.
3 Place the autoloader down into the shipping box and push the back
of the autoloader towards the back end of the box.
4 Insert the empty accessory kit box (or filler tube) into the shipping
box at the front end of the autoloader in the space between the
autoloader foam inserts and the shipping container.
5 Place any necessary paperwork on top of the autoloader inside the
box.
6 Close and seal the box.
7 Place the shipping label on the box.
Errors are problems that occur while operating the autoloader. They
prevent the autoloader from completing a specific action. When an error
occurs, two things can happen:
•
No error message appears, but the autoloader fails to complete the
action.
•
An error message appears on the front panel or in the On-board
Remote Management screen (see
page 123).
SuperLoader 3 Autoloader User's Guide
Hard Error Log Display
8
on
Advertisement
Table of Contents
