Chapter 7 Customer Replaceable Units (CRUs)
Rack Mounting the Autoloader
Figure 16 Front
Alignment
Figure 17 Connecting
Support Brackets
94
6 While the other installer holds the front end of the autoloader, secure
the autoloader in the rack by doing the following:
a
Secure the front end of the autoloader to the rack using four rack
screws (two per tab) as shown in
just enough to secure the autoloader to the front rails.
Front rail
Rack
screws
Tab (one
per side)
b
Install four screws (two per side) to secure the support brackets
to the autoloader brackets (see
Screws
7 Verify that the autoloader is level. Adjust as needed.
SuperLoader 3 Autoloader User's Guide
figure
16. Tighten the screws
Autoloader (front)
figure
17).
Support bracket
Autoloader
bracket