Chapter 4 On-board Remote Management
Commands Page
Commands Page
Inventory
4
Set to Home
4
56
You can move tapes, run a system inventory, reset the picker to its home
position, or perform sequential operations from the
When you click
Commands
From a remote location, you can request that a tape be moved from one
position to another. To move a tape:
1 From any page, click the
displays.
2 From the
Moving Tapes
menu under
From:
want to move.
You can also click the slot on the graphic of the autoloader
Note:
magazine to select and move a cartridge.
3 From the drop-down menu under
you want to move the tape, and then click
The autoloader automatically runs an inventory whenever you power it
on or insert a magazine. If you need to run an inventory in addition to
this, you can use On-board Remote Management to do it remotely. To
run an inventory:
1 From any page, click the
displays.
2 From the
Commands
inventory immediately.
If the autoloader is not able to successfully execute a
command, try executing a
Inventory
retry the move or inventory command again.
The
command resets the autoloader as a means to help the
Set to Home
autoloader recover from an unexpected internal condition. To set to
:
Home
SuperLoader 3 Autoloader User's Guide
, the page displays.
heading. The
Commands
section of the page, click the drop-down
and select the current location of the tape that you
, select the location to which
To:
heading. The
Commands
page, click
Inventory
Set to Home
page.
Commands
screen
Commands
.
submit
screen
Commands
. The autoloader starts an
or an
Moving Tapes
command, and then
4