Table of Contents
Advertisement
Chapter 3 Operating the Autoloader
Using Cartridges
Moving a Single
Cartridge
3
Ejecting a Single
Cartridge
3
28
After
Load cartridge
a cartridge through the mailslot before it relocks. The autoloader
automatically loads the cartridge into the selected slot.
Note:
If the load cartridge function fails, the cartridge ejects and
you will have to perform steps
5 Once you have inserted the cartridge, the prompt
appears. You have 20 seconds to press
You can easily move a single cartridge from one location to another
inside the autoloader.
1 From the main menu, scroll to
2 From the
Commands
The
screen appears under
Move
the cartridge you want to move. Slots that are occupied by a data
cartridge are indicated by an asterisk (
3 From To:, scroll to the location to which you want to move the
cartridge. Slots that are occupied by a data cartridge are indicated by
an asterisk (
). Press
*
4 Press
.
Enter
If you select an empty location,
LCD. Choose a different location.
If you select a location that is already occupied,
appears on the LCD. Choose a different location.
When you want to remove a single cartridge from the autoloader, you
can specify the cartridge you want by bar code or location, or choose the
cartridge currently in the tape drive.
To eject a cartridge by bar code (if you have a bar code reader):
1 From the main menu, scroll to
2 From the
Commands
3 From the
submenu, scroll to
Eject
press
.
Enter
SuperLoader 3 Autoloader User's Guide
appears on the LCD, you have 20 seconds to load
Enter
Commands
submenu, scroll to
Move
.
Scroll to the current location of
From:
).
*
.
Enter
No Source Element
Commands
submenu, scroll to
Eject
scroll to
Tape,
3
and
4
again.
Enter to Continue
in response.
, and then press
Enter
, and then press
Enter
appears on the
Destination Full
, and then press
Enter
, and then press
Enter
, and then
Mailslot
.
.
.
.
Advertisement
Table of Contents
