Table of Contents
Advertisement
Sequential Mode
Operations
5
To set the
Change Mode
1 From the main menu, scroll to
2 From the
Configuration
. the mode options appear. A check mark appears next to the
Enter
currently enabled mode.
3 Do one of the following:
•
To leave the mode the same, press
•
To modify the change mode, scroll to the mode to which you
want to set the autoloader and press
appears on the LCD.
mode
4 Press and hold the power button on the front panel until
Shutdown wait 60 sec
LCD and the autoloader shuts off.
5 Press the power button again to power up the autoloader. The new
change mode is now in effect.
If you enable
Sequential
under the
Commands
•
The
command allows you to load the first cartridge.
Start
•
The
command allows you to continue from the next unused
Resume
slot, if a user stopped the cycle.
•
The
command allows you to stop the cycle.
Stop
To start
mode operation:
Sequential
1 From the main menu, scroll to
2 From the
Commands
.
Enter
3 From the
Sequential Ops
Moving first tape to drive
To stop
mode operation:
Sequential
1 From the main menu, scroll to
2 From the
Commands
.
Enter
SuperLoader 3 Autoloader User's Guide
:
Configuration
menu, scroll to
Change Mode
Escape
appears on the LCD.
mode, you must use the
menu to operate the autoloader after you reboot.
Commands
menu, scroll to
Sequential Ops
menu, scroll to
appears on the LCD.
Commands
menu, scroll to
Sequential Ops
Chapter 5 Administration
Setting the Change Mode
, and then press
Enter
, and then press
.
.
Enter
Reboot to enable new
System
appears on the
Power Off
submenu
Sequential Ops
, and then press
Enter
, and then press
, and then press
Start
Enter
, and then press
Enter
, and then press
.
.
.
.
69
Advertisement
Table of Contents
