Chapter 2 Installation and Configuration
Accessories
Accessories
8
General Information
Your SCSI host adaptor card must also support the SCSI bus type used to
connect the autoloader. If you use a LVD SCSI bus, use a host adapter
card with a connection for a VHDCI cable.
Note:
If you use a single-ended (SE) SCSI bus, the tape drive's
performance is limited to the maximum data transfer speed of
the bus.
Note:
The maximum number of autoloaders supported per SCSI bus
is four.
Note:
The autoloader may not work with multiple SCSI LUNS when
attached to a RAID controller. The autoloader is not
recommended for use with a RAID controller. If this problem
occurs, it is recommended that the autoloader be attached to a
separate SCSI bus controller on the host or server.
The following accessories are shipped with the Quantum SuperLoader 3
autoloader:
•
Quantum SuperLoader 3 Quick Start Guide
•
SCSI host cable
•
SCSI terminator
•
Hardware to rack mount the autoloader
•
T8 and T10 TORX
•
One magazine blank
•
Power cable
SuperLoader 3 Autoloader User's Guide
®
L-Key drivers
2
2