Table of Contents
Advertisement
Chapter 4 On-board Remote Management
On-board Remote Management Overview
Opening On-board
Remote
Management
4
42
options, networking options, security options, running diagnostic tests,
and performing system updates.
Note:
Only use the
known to be idle and unavailable to host backup/restore
applications. Use of the
Remote Management should not be issued while the
autoloader is being used by host applications. The autoloader
will recognize when the drive or autoloader is executing host
commands and will respond appropriately to prevent
application failures. A
between host application commands may not be recognized
resulting in a failed application, such as a failed backup/
restore job.
To log out of the system, you must close your browser to end
Note:
the session.
On-board Remote Management has an HTML interface, which means
you use a browser to open it. The following Web browsers are supported:
•
For Microsoft Windows—Microsoft Internet Explorer 5.5 or later
•
For Microsoft Windows 2003—Microsoft Internet Explorer 6.0 or later
(with latest security patches)
®
•
For Redhat
2.1—Mozilla™ 1.4.2
•
Firefox™ 1.0
You need an operator password to access the
need an administrator password to access the
and
pages.
Updates
To open On-board Remote Management:
1 From your computer, open your Web browser.
2 In the browser's address field, enter the IP address for your
autoloader (see
Viewing Ethernet Information
SuperLoader 3 Autoloader User's Guide
command when the autoloader is
Diagnostic
Diagnostic
command being issued
Diagnostic
commands from On-board
page, and you
Commands
,
Configuration
Diagnostics
on page 38).
,
Advertisement
Table of Contents
