Chapter 7 Customer Replaceable Units (CRUs)
Rack Mounting the Autoloader
Figure 14 Attaching
Support Brackets
Outer cover of rack
92
4 Using rack screws, attach a support bracket to the clip nuts on each
rear rail (see
figure
Note:
Be sure to attach the support brackets correctly; the side of
the bracket with only two holes should be secured to the
rail.
Tighten the screws just enough to hold the support brackets firmly
against the rail while still allowing the support bracket to be slightly
shifted by hand. This shifting will help facilitate the engagement of
autoloader brackets as the autoloader is installed in the rack. You will
fully tighten the screws in
SuperLoader 3 Autoloader User's Guide
14.)
step
8.
Support bracket
Clip nuts
Rear rail in rack
Rack
screws