Table of Contents
Advertisement
Chapter 3 Operating the Autoloader
Running an Inventory
Viewing Ethernet
Information
3
Table 6 Ethernet
Information Fields
Running an Inventory
38
To view the Ethernet information, use the following procedure.
1 From the main menu, scroll to
2 From the
submenu, scroll to
Status
A list of messages appears. These messages may include:
Field
Description
MAC Address
Indicates the unique network identifier associated
with the autoloader.
IP Address
indicates the static IP address or currently assigned
dynamic IP address. The text
case.
Network
Indicates whether the autoloader is connected to the
network or not and at what speed.
The autoloader automatically runs an inventory whenever you power it
back on or insert a magazine. An inventory checks each magazine slot,
the drive, the picker, and the mailslot to determine if a cartridge is
present. If so, it also reads the bar code label, if available. If you need to
run an inventory in addition to this, you can do so manually.
Note:
No bar code labels can be read if there is a tape in the picker.
To perform an inventory manually:
1 From the main menu, scroll to
2 From the
Commands
. The autoloader scans the bar codes of all the cartridges present.
Enter
SuperLoader 3 Autoloader User's Guide
, and then press
Status
Ethernet
, and then press
Commands
submenu, scroll to
Inventory
.
Enter
, and then press
Enter
displays in this
DHCP
.
Enter
, and then press
.
3
Advertisement
Table of Contents
