Table of Contents
Advertisement
Chapter 5 Administration
Setting the Change Mode
Setting Security
5
Setting
Magazines5
70
3 From the
Sequential Ops
Ejecting tape from drive
To resume
Sequential
1 From the main menu, scroll to
2 From the
Commands
.
Enter
3 From the
Sequential Ops
.
Enter
Moving next tape to drive
You can add security to the front panel by password-protecting the
autoloader's functionality. The security setting only protects the front
panel functionality. The default setting is
is required. However, you can enable the security option so that users
must enter a password to access functionality.
Security Option
When you first power on the autoloader, the security option is set to
Use the following procedure to enable the security option. You must have
an administrator-level password to set passwords.
To set the security option:
1 From the main menu, scroll to
2 From the
Configuration
appears after the word, the security option is
appears, the security option is
3 To change the option, press
was set to
, it is now set to
On
In some cases, autoloader owners were being charged Independent
Software Vendor (ISV) licensing fees for two-magazine SuperLoader 3s
although only one magazine was configured. This occurred because the
ISV software was registering the autoloader as a two-magazine device,
regardless of the number of magazines configured. You have the ability
to set the number of magazines in the autoloader.
SuperLoader 3 Autoloader User's Guide
menu, scroll to
appears on the LCD.
mode operation:
Commands
menu, scroll to
Sequential Ops
menu, scroll to
appears on the LCD.
Off
Configuration
menu, scroll to
Security
.
Off
. For example, if the security option
Enter
, and no check mark appears.
Off
, and then press
Stop
Enter
, and then press
Enter
, and then press
, and then press
Resume
, meaning that no password
, and then press
Enter
. If a check mark
. If no check mark
On
.
.
5
.
Off
.
Advertisement
Table of Contents
