Setting The Ip Address - Freecom SUPERLOADER3 LTO2-HH Manual

Setting the IP
Address 5
• A Simple Network Management Protocol (SNMP) server (optional)
• A time server, or set the time and time zone manually (optional)
An IP address is the address of any device attached to a network. Each
device must have a unique IP address. IP addresses are written as four
sets of numbers separated by periods ranging from
including
255.255.255.255
IP addresses are either permanent or dynamically assigned. A
permanent, or static, address remains the same each time the device
connects to the network. A dynamic address may change each time the
device connects to the network server using Dynamic Host Configuration
Protocol (DHCP).
To set a dynamic IP address:
1 From the main menu, scroll to
2 From the
Configuration
3 From the
Ethernet
4 Scroll to , and then press
DHCP
appears on the LCD screen.
5 Press and hold the power button on the front panel until
Shutdown wait 60 sec
LCD, then the autoloader shuts off.
6 Press the power button again to power on the autoloader. The IP
address is changed.
To set a static IP address:
1 From the main menu, scroll to
2 From the
Configuration
3 From the
Ethernet
4 Scroll to , and then press
Static IP
appears at the first digit.
5 At each position of the IP address, use the up and down arrows to
change the value of each digit. Press
the next digit.
SuperLoader 3 Autoloader User's Guide
.
Configuration
menu, scroll to
Ethernet
submenu, scroll to
Set IP
.
Enter Please reboot to use DHCP
appears on the LCD.
Configuration
menu, scroll to
Ethernet
submenu, scroll to
Set IP
. The cursor automatically
Enter
Enter
Chapter 5 Administration
Configuring the Autoloader
up to and
0.0.0.0
, and then press
Enter
, and then press
, and then press
Enter
System
appears on the
Power Off
, and then press
Enter
, and then press
, and then press
Enter
to advance the cursor to
.
.
Enter
.
.
.
Enter
.
63