Figure 8 Attaching Scsi And Power Cables - Freecom VALUELOADER LTO User Manual

Installing the ValueLoader
Connecting the SCSI and Power Cables
Figure 8 Attaching
SCSI and Power
Cables
14
Attach one end of the SCSI cable (included in the accessory kit)
2
to one of the connectors on the rear panel of the ValueLoader.
See figure 8.
Attach the other end of the SCSI cable to the connector on the
3
SCSI host adapter or to the connector on the previous device on
the SCSI bus.
If the supplied SCSI cable does not fit the connector
Note:
on your SCSI host adapter, you either have an
incompatible SCSI host adapter, or you need to
purchase a cable adapter. For clarification, contact
your service representative or SCSI host adapter
manufacturer.
If the ValueLoader is the last (or only) device on the SCSI bus,
4
attach the terminator to the remaining SCSI connector on the
rear panel of the ValueLoader, as shown in
attach the cable to the next device on the SCSI bus. Make sure
the last device on the SCSI bus is properly terminated.
Attach the power cable to the power connector on the rear
5
panel of the ValueLoader as shown in
ValueLoader LTO Tape Autoloader User Manual
figure 8. Otherwise,
figure 8.