Tools And Parts Required; Replacing The Console Port Cable; Replacing A Pim - Juniper J2300 User Manual

J-series™ Services Router User Guide

Tools and Parts Required

To replace hardware components, you need the tools and parts listed in Table 198.
Table 198: Tools and Parts Required
Tool or Part
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD)
grounding wrist strap
Phillips (+) screwdriver, number 2

Replacing the Console Port Cable

The RJ-45 port labeled
you to connect the router to an external management device, such as a
laptop or a terminal server. For cable specifications, see "Network Cable
Specifications and Connector Pinouts" on page 551.
To replace the console port cable, follow this procedure:
1.
2.
3.

Replacing a PIM

Physical Interface Modules (PIMs) in J4300 and J6300 Services Routers are field
replaceable. The router must be powered off before the PIMs are removed or
installed. This section contains the following topics:
518
Replacing Hardware Components
Components
All
All
PIM
DRAM
Compact flash
CONSOLE
Locate an appropriate replacement cable and connector.
Plug the Ethernet connector at either end of the cable into the
on the front panel (see Figure 22 and Figure 23).
Plug the connector at the other end of the cable into the external management
device. If you are connecting to a DB-9 serial port, use the provided RJ-45
to DB-9 serial port adapter.
"Removing a PIM" on page 519
"Installing a PIM" on page 520
on the Services Router's front panel allows
port
CONSOLE