Juniper J2300 User Manual page 350

J-series™ Services Router User Guide
To configure stub areas and NSSAs in an OSPF network like the
one shown in Figure 85:
1.
2.
3.
4.
5.
6.
Table 119: Configuring Stub Area and Not-So-Stubby Area Routers
Task
Navigate to the 0.0.0.7 level in the
configuration hierarchy.
Configure each Services Router in area
0.0.0.7 as a stub router.
320
Configuring an OSPF Network with a Configuration Editor
Create the area and enable OSPF on the interfaces within that area.
For instructions, see "Creating Additional OSPF Areas" on page 317.
Configure an area border router to bridge the areas.
For instructions, see "Configuring Area Border Routers" on page 318.
Navigate to the top of the configuration hierarchy in either the J-Web or the CLI
configuration editor.
To configure each Services Router in area
the configuration tasks described in Table 119.
If you are finished configuring the network, commit the configuration.
Go on to one of the following procedures:
To improve network operation, see "Tuning an OSPF Network for Efficient
Operation" on page 321.
To check the configuration, see "Verifying an OSPF Configuration" on
page 325.
J-Web Configuration Editor
In the configuration editor hierarchy,
select Protocols>Ospf>Area id
0.0.0.7.
1. In the Stub option list, select Stub
and click OK.
2. Repeat Step 1 for every Services
Router in the stub area to configure
them with the stub parameter for
the area.
as a stub area router, perform
0.0.0.7
CLI Configuration Editor
From the top of the configuration
hierarchy, enter
edit protocols ospf area 0.0.0.7
1. Set the stub attribute:
set stub
2. Repeat Step 1 for every Services
Router in the stub area to configure
them with the stub parameter for
the area.