Before You Begin; Using The Monitoring Tools - Juniper J2300 User Manual

address 127.0.0.1/32;
For a complete list of the filters, type a command, followed by the
pipe, followed by a question mark (?):
Possible completions:
You can specify complex expressions as an option for the
For more information about command output filtering and creating match
expressions, see the JUNOS System Basics Configuration Guide.
NOTE: To filter the output of configuration mode commands, use the filter
commands provided for the operational mode commands. In configuration
mode, an additional filter is supported. See "Filtering Configuration Command
Output" on page 130.

Before You Begin

To use the J-Web interface and CLI operational tools, you must have the appropriate
access privileges. For more information about configuring access privilege levels, see
"Adding New Users" on page 175 and the JUNOS System Basics Configuration Guide.

Using the Monitoring Tools

This section describes the monitoring tools in detail. It contains the following topics:
user@host> show configuration | ?
compare Compare configuration changes with prior version
count Count occurrences
display Show additional kinds of information
except Show only text that does not match a pattern
find Search for first occurrence of pattern
hold Hold text without exiting the --More-- prompt
last Display end of output only
match Show only text that matches a pattern
no-more Don't paginate output
request Make system-level requests
resolve Resolve IP addresses
save Save output text to file
trim Trim specified number of columns from start of line
Monitoring System Properties on page 204
Monitoring the Chassis on page 206
Monitoring the Interfaces on page 208
Monitoring and Diagnosing a Services Router
and
match except
Using the Monitoring Tools
filters.
203