Service - Juniper J2300 User Manual

J-series™ Services Router User Guide
4.
Table 124: BGP Routing Quick Configuration Summary
Field
Router Identification
Router Identifier (required)
BGP
Enable BGP
Autonomous System Number
Peer Autonomous System Number
Peer Address
Local Address
334
Configuring a BGP Network with Quick Configuration
To apply the configuration and return to the Quick Configuration Routing
page, click OK.
To cancel your entries and return to the Quick Configuration Routing
page, click Cancel.
To check the configuration, see "Verifying a BGP Configuration" on page 344.
Function
Uniquely identifies the router
Enables or disables BGP.
Sets the unique numeric identifier of
the AS in which the services router is
configured.
Sets the unique numeric identifier of
the AS in which the peer host resides.
Specifies the IP address of the peer
host's interface to which the BGP
session is being established.
Specifies the IP address of the local
host's interface from which the BGP
session is being established.
Your Action
Type the Services Router's 32-bit IP
address, in dotted decimal notation.
To enable BGP, select the check
box.
To disable BGP, clear the check
box.
Type the Services Router's 32-bit AS
number, in dotted decimal notation.
If you enter an integer, the value is
converted to a 32-bit equivalent. For
example, if you enter 3, the value
assigned to the AS is 0.0.0.3.
Type the peer host's 32-bit AS number,
in dotted decimal notation.
If you enter an integer, the value is
converted to a 32-bit equivalent. For
example, if you enter 3, the value
assigned to the AS is 0.0.0.3.
Type the IP address of the peer host's
adjacent interface, in dotted decimal
notation.
Type the IP address of the local host's
adjacent interface, in dotted decimal
notation.