Juniper J2300 User Manual page 525

Table 191: Configuring a NAT Pool for IPSec
Task
Configure the NAT pool from which
the addresses for network address
translation are taken.
J-Web Configuration Editor
1. From the top of the configuration
hierarchy, click Services>Nat.
2. In the Pool field, click Add new
entry.
3. In the Pool name field, type the
name of the NAT pool. It can be
any unique string less than 64
characters long.
4. In the Address choice field, select
Address from the drop-down
menu.
5.
In the Address box, type the
IP address of the local tunnel
endpoint, in dotted decimal
notation.
Configuring an IPSec Tunnel with a Configuration Editor
Configuring IPSec for Secure Packet Exchange
CLI Configuration Editor
1. From the top of the configuration
hierarchy, enter
edit services nat
2.
Add the local tunnel endpoint to
the NAT address pool:
set pool pool-name address
1.1.1.1
495