Juniper J2300 User Manual page 545

NOTE: If you cannot connect to the router through the
router by pressing and holding the power button on the front panel until the
ON
by pressing the power button again. The
remains steadily green when the router is operating normally.
Table 197 describes the
Table 197: CLI Request System Halt Command Options
Option
none
at time
in minutes
media type
message "text"
LED turns off. Once the router has shut down, you can power on the router
request system halt
Description
Same as at now (stops software processes on the router immediately).
Time at which to stop the software processes on the router. You can specify time in
one of the following ways:
now—Stops the software processes immediately. This is the default.
+ minutes —Stops the software processes in the number of minutes from
now that you specify.
yymmddhhmm —Stops the software processes at the absolute time you
specify. Enter the year, month, day, hour (in 24-hour format), and minute.
hh:mm —Stops the software processes at the absolute time that you specify,
on the current day. Enter the time in 24-hour format, using a colon (:) to
separate hours from minutes.
Specifies the number of minutes from now to stop the software processes on the
router. This option is a synonym for the at + minutes option.
Specifies the boot device to boot the router from after the halt:
compact-flash—Reboots from the primary compact flash drive. This is the
default.
removable-compact-flash—Reboots from the optional removable compact
flash drive. This option is available on J4300 and J6300 Services Routers only.
usb—Reboots from the USB drive.
Provides a message to display to all system users before the software processes on
the router are stopped.
Performing Software Upgrades and Reboots
port, shut down the
CONSOLE
LED lights during startup and
POWER ON
command options.
Halting the Services Router with the CLI
POWER
515