Juniper J2300 User Manual page 486

J-series™ Services Router User Guide
Task
Create the firewall filter choose-vc to
select the traffic that is transmitted on a
particular virtual channel.
Apply the firewall filter choose-vc
to output traffic on the t3–1/0/0.0
interface.
456
Configuring CoS with DiffServ with a Configuration Editor
J-Web Configuration Editor
1.
Navigate to the top of the
configuration hierarchy and select
Firewall.
2. Click Add new entry next to Filter.
3.
In the Filter name box, enter
the name of the firewall
filter—choose-vc.
4.
Click Add new entry next to Term.
5. In the Rule name box, enter
the name of the firewall
term—branch1.
6.
Click Configure next to From.
7. Click Add new entry next to
Destination address.
8. In the Address box, enter the
IP address of the destination
host—192.168.10.0/24.
9.
Click OK twice.
10. On the firewall term page, click
Configure next to Then.
11. Select Accept from the
Designation box.
12. In the Virtual channel
box, enter the name of the
previously configured virtual
channel—branch1–vc.
13.
Click OK.
14. Repeat these steps for the
virtual channels branch2–vc and
branch3–vc.
1. Navigate to the top of the
configuration hierarchy and select
Interfaces.
2.
Click t3–1/0/0 in the list of
configured interfaces.
3. Click 0 in the list of configured
logical units for the interface.
4.
Click Edit next to Inet.
5.
Click Configure next to Filter.
6. In the Output box, enter the
name of the previously configured
firewall filter—choose–vc.
7.
Click OK.
CLI Configuration Editor
1.
From the top of the configuration
hierarchy, enter
edit firewall
2. Enter
set family inet filter choose-vc
term branch1 from destination
192.168.10.0/24
3. Enter
set family inet filter choose-vc term
branch1 then accept
4. Enter
set family inet filter choose-vc
term branch1 then virtual-channel
branch1–vc
5. Repeat these steps for virtual
channels branch2–vc and
branch3–vc.
1. From the top of the configuration
hierarchy, enter
edit interfaces
2.
Enter
set t3–1/0/0 unit 0 family inet
filter output choose-vc