Monitoring Nat Pools - Juniper J2300 User Manual

Table 79: Summary of Key IPSec Output Fields
Field Values
IPSec Tunnels
Service Set
Name of the service set for which the IPSec tunnel is defined.
Rule Name of the rule set applied to the IPSec tunnel.
Term Name of the IPSec term applied to the IPSec tunnel.
Local Gateway Gateway address of the local system.
Remote Gateway
Gateway address of the remote system.
Direction
Direction of the IPSec tunnel: Inbound or Outbound.
Protocol Protocol supported: either Encapsulation Security Protocol (ESP) or Authentication Header and
ESP (AH+ESP).
Tunnel Index Numeric identifier of the IPSec tunnel.
Tunnel Local Identity Prefix and port number of the local endpoint of the IPSec tunnel.
Tunnel Remote Prefix and port number of the remote endpoint of the IPSec tunnel.
Identity
IPSec Statistics
Service Set Name of the service set for which the IPSec tunnel is defined.
Local Gateway Gateway address of the local system.
Remote Gateway
Gateway address of the remote system.
ESP Encrypted Bytes Total number of bytes encrypted by the local system across the IPSec tunnel.
ESP Decrypted Bytes Total number of bytes decrypted by the local system across the IPSec tunnel.
AH Input Bytes
Total number of bytes received by the local system across the IPSec tunnel.
AH Output Bytes
Total number of bytes transmitted by the local system across the IPSec tunnel.

Monitoring NAT Pools

NAT pool information includes information about the address ranges configured
within the pool on the Services Router. To view NAT pool information, select
Monitor>NAT in the J-Web interface, or enter the following CLI
Table 80 summarizes key output fields in NAT displays.
Table 80: Summary of Key NAT Output Fields
Field Values
NAT Pools
NAT Pool Name of the NAT pool.
Pool Start Address Lower address in the NAT pool address range.
show services nat pool
Monitoring and Diagnosing a Services Router
command:
show
Using the Monitoring Tools
217