Starting The Cli - Juniper J2300 User Manual

J-series™ Services Router User Guide
Figure 33: CLI Command Hierarchy Example
To execute a command, you enter the full command name, starting at the top level
of the hierarchy. For example, to display a brief view of the routes in the routing
table, use the command
The hierarchical organization results in commands that have a regular syntax and
provides the following features that simplify CLI use:

Starting the CLI

To start the CLI:
1.
2.
118
Using the Command-Line Interface
bgp isis
....... .......
brief
show route brief
Consistent command names—Commands that provide the same type of
function have the same name, regardless of the portion of the software
they are operating on. For example, all
information and statistics, and all
system information.
Lists and short descriptions of available commands—Information about
available commands is provided at each level of the CLI command hierarchy. If
you type a question mark (?) at any level, you see a list of the available
commands along with a short description of each command.
Command completion—Command completion for command names
(keywords) and command options is also available at each level of the
hierarchy. If you type a partial command name followed immediately by a
question mark (with no intervening space), you see a list of commands that
match the partial name you typed.
Establish a connection with the Services Router:
To access the router remotely from the network, enter the command
you typically use to establish a remote connection (such as
) using the router hostname.
ssh
To access the router through a management device attached to the
console port, start the terminal application.
Log in using your username and password.
After you log in, you enter a UNIX shell.
show
ospf route
.......
exact protocol
.
commands display software
show
commands erase various types of
clear
system
.......
table terse
or
telnet