Using The Monitor Interface Command - Juniper J2300 User Manual

Table 86: CLI traceroute Command Options
Option
host
interface source-interface
as-number-lookup
bypass-routing
gateway address
logical-router
logical-router-name
inet
no-resolve
routing-instance
routing-instance-name
source address
tos number
ttl number
wait seconds
Following is sample output from a
traceroute to 173.24.232.66 (172.24.230.41), 30 hops max, 40 byte packets
The fields in the display are the same as those displayed by the J-Web traceroute
diagnostic tool. Table 84 summarizes these output fields.

Using the monitor interface Command

Use the CLI
alarm, and filter statistics about a physical or logical interface. Enter
the command with the following syntax:
Replace
specify the
Description
Sends traceroute packets to the hostname or IP address you specify.
Sends the traceroute packets on the interface you specify. If you do not include this option,
traceroute packets are sent on all interfaces.
Displays the autonomous system (AS) number of each intermediate hop between the router
and the destination host.
Bypasses the routing tables and send the traceroute packets only to hosts on directly attached
interfaces. If the host is not on a directly attached interface, an error message is returned.
Uses the gateway you specify to route through.
Sends traceroute packets to this logical router.
Forces the traceroute packets to an IPv4 destination.
Suppresses the display of the hostnames of the hops along the path.
Uses the routing instance you specify for the traceroute.
Uses the source address you specify in the traceroute packet.
Sets the type-of-service (TOS) value in the IP header of the traceroute packet. Specify a value
from 0 through 255.
Sets the time-to-live (TTL) value for the traceroute packet. Specify a hop count from 0 through
255.
Sets the maximum time to wait for a response.
user@host> traceroute host2
1 173.18.42.253 (173.18.42.253)
2 host4.site1.net (173.18.253.5)
3 host5.site1.net (173.18.253.5)
4 173.24.232.65 (173.24.232.65)
5 173.24.232.66 (173.24.232.66)
monitor interface
user@host> monitor interface ( interface-name | traffic)
with the name of a physical or logical interface. If you
interface-name
option, statistics for all active interfaces are displayed.
traffic
Monitoring and Diagnosing a Services Router
command:
traceroute
0.482 ms 0.346 ms
0.401 ms 0.435 ms
0.401 ms 0.360 ms
0.420 ms 0.456 ms
0.830 ms 0.779 ms
command to display real-time traffic, error,
Using CLI Diagnostic Commands
0.318 ms
0.359 ms
0.357 ms
0.378 ms
0.834 ms
229