Juniper J2300 User Manual page 118

J-series™ Services Router User Guide
Field
Enable CHAP
CHAP Local Identity (available if CHAP is enabled)
Use System Host Name
Local Name
CHAP Peer Identity
CHAP Secret
E1 Options
MTU
Clocking
Framing Mode
Invert Data
88
Configuring Network Interfaces with Quick Configuration
Function
Enables or disables CHAP authentication
on an E1 interface with PPP
encapsulation only.
Specifies that the E1 interface use the
Services Router's system hostname in
CHAP challenge and response packets.
If Use System Host Name is disabled,
specifies the local name for CHAP to use.
Identifies the client or peer with which
the Services Router communicates on
this E1 interface.
Specifies the secret password for CHAP
authentication, known to both sides of
the connection.
Specifies the maximum transmission
unit size for the E1 interface.
Specifies the transmit clock source for
the E1 line.
Specifies the framing mode for the E1
line.
Enables or disables data inversion.
Data inversion is normally used only in
alternate mark inversion (AMI) mode.
Your Action
To enable CHAP, select the
check box.
To disable CHAP, clear the check
box.
To enable, select the check box
(the default).
To disable, clear the check box.
Type a local name for this E1 interface.
Type the CHAP client name.
Type a password that is known to the
other side of the connection. Use a
combination of letters and numbers
that is difficult for others to guess.
Type a value between 256 and 9192
bytes. The default MTU for E1 interfaces
is 1504.
From the drop-down list, select one of
the following:
internal—Services Router's
own system clock (the default)
external—Clock received from
the E1 interface
From the drop-down list, select one of
the following:
g704—The default
g704–no-crc4—G704 without
cyclic redundancy check 4
(CRC4)
unframed—Unframed
transmission format
To enable, select the check box.
To disable, clear the check box.