Service - Juniper J2300 User Manual

Table 127: Configuring a Route Reflector
Task
On the Services Router that you are
using as a route reflector, navigate to the
Bgp level in the configuration hierarchy.
On the Services Router that you are
using as a route reflector, create the
BGP group cluster-peers, and add to the
group the IP addresses of the internal
neighbors that you want in the cluster.
On the Services Router that you are
using as a route reflector, set the group
type to internal.
On the Services Router that you are
using as a route reflector, configure the
cluster identifier for the route reflector.
To check the configuration, see "Verifying a BGP Configuration" on
page 344.
J-Web Configuration Editor
In the configuration editor hierarchy,
select Protocols>Bgp.
1. In the Group box, click Add new
entry.
2. In the Group name box, type the
name of the group in which the BGP
peer is configured—cluster-peers
in this case.
3. In the Neighbor box, click Add new
entry.
4. In the Address box, type the IP
address of a BGP peer, in dotted
decimal notation.
5.
Click OK.
6. Repeat Step 3 and Step 4 for each
BGP neighbor within the cluster
that you are configuring.
From the Type drop-down menu, select
internal.
1.
In the Cluster box, enter the unique
numeric cluster identifier.
2. Click OK.
Configuring BGP Networks with a Configuration Editor
Configuring BGP Sessions
CLI Configuration Editor
From the top of the configuration
hierarchy, enter
edit protocols bgp
1. Create the group cluster-peers,
and add the address of an internal
neighbor:
set group cluster-peers neighbor
192.168.6.4
2.
Repeat Step 1 for each BGP
neighbor within the cluster that
you are configuring.
From the [edit protocols bgp group
internal-peers] hierarchy level:
set type internal
Set the cluster identifier:
set cluster 2.3.4.5
341