Authentication Event - Cisco Catalyst 3560X-24P Command Reference Manual

authentication event

authentication event
Use the authentication event interface configuration command to set the actions for specific
authentication events on the port.
action
Syntax Description
alive
authorize
dead
fail
linksec fail action
next-method
no-response
reinitialize
retry
retry count
server
vlan
vlan-id
Defaults No event responses are configured on the port.
Command Modes Interface configuration
Command History Release
12.2(53)SE2
Catalyst 3750-X and 3560-X Switch Command Reference
2-26
authentication event {[linksec] fail [action [authorize vlan vlan-id | next-method] {| retry {retry
count}]} { no-response action authorize vlan vlan-id} {server {alive action reinitialize} |
{dead action [authorize | reinitialize vlan vlan-id]}}
Configure the required action for an authentication event.
Configure the authentication, authorization, and accounting (AAA) server
alive actions.
Authorize the port.
Configure the AAA server dead actions.
Configure the failed-authentication parameters.
See the authentication event linksec fail action
Move to next authentication method.
Configure the non-responsive host actions.
Reinitialize all authorized clients
Enable retry attempts after a failed authentication.
Number of retry attempts from 0 to 5.
Configure the actions for AAA server events.
Specify the authentication-fail VLAN from 1 to 4094.
VLAN ID number from 1 to 4094.
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
command.
OL-21522-02