Error Message List - Roland GR-640 User Manual

Error Message List

Index Solution
Press any key to cancel setup and clear
the error message. Move the pinch
rollers to the correct positions and
reload the material.
* Note: If the message appears even if
the pinch rollers are moved to the
correct positions, the machine may be
exposed to direct sunlight or intense
indoor lighting. Turn off the power, and
then move the machine to a location
where it is not exposed to direct
sunlight or intense lighting.
After moving the machine, turn on the
power.
Turn off the power, and then remove
any dust and other foreign materials
from the area around the cutting
carriage. After performing this
operation, turn on the power.
Press any key to clear the error
message. Reload the material.
Press any key to clear the error
message. Reload the material.
Press any key to clear the error
message. Reload the material or change
the position of crop mark 2.
First, delete the data stored in the
machine.
Prepare the Data for Recutting
Next, decrease the size of the data sent
from the computer and resend it. Then
carry out a REPLOT.
Cutting the Same Object Repetitively
Press any key to clear the error
message. Review the data sent from
the computer, and then send the
correct data.
Cause
Pinch rollers are at positions where the
material cannot be pinched.
It is not possible to adjust the height of
the cutting carriage.
Crop mark 2 or 3 is slanted by 5
degrees or more.
Crop mark 3 is offset by 20 mm or
more in the material movement
direction.
Crop mark 2 is offset by 20 mm or
more in the carriage direction.
The amount of data stored in the
machine is too large and REPLOT
cannot be executed.
Data that the machine is not able to
interpret was sent.
The number of parameters differs from
the permissible number.
The value of the specified parameter
was outside the permissible range.
A heavy load was placed on the motor,
and the operation stopped.