Table of Contents
Advertisement
Error Messages
This section describes the error messages that may appear on the machine's display and how to take
action to remedy the problem. If the action described here does not correct the problem or if an error
message not described here appears, contact your authorized Roland DG Corporation dealer.
"Error; Rollers Are /Up Sensor"
An error occurred during the measurement of material size.
Lower two or more pinch rollers.
RELATED LINKS
・ P. 22 "Precautions for Loading Materials"
"Error; Check Media Or Drum Or X Motor"
An error occurred in the X motor.
After you switch off the power, inform your authorized Roland DG Corporation dealer of the message
that appeared on the display.
"Error; Check Media Or Y Motor"
An error occurred in the Y motor.
After you switch off the power, inform your authorized Roland DG Corporation dealer of the message
that appeared on the display.
"Error; Check Carriag Sensor Or VC Motor"
An error occurred in the VC motor.
After you switch off the power, inform your authorized Roland DG Corporation dealer of the message
that appeared on the display.
"Out Of Space; # of Copies finished"
Material size is not sufficient for a cutting test.
Check the material and change the size.
"HPGL/2 Cmd. Error"
Machine received an undefined command.
Check the file settings.
RELATED LINKS
・ P. 49 "Performing Cutting"
"Communication Error Setup Press MISC"
Communication settings between RS-232 and computer do not match when receiving commands
from the computer.
Check the communication settings.
Messages on the Operation Panel
163
Advertisement
Table of Contents
