Table of Contents
Advertisement
stolen.)
• Set the electronic key to battery-saving
mode to disable the smart access system
with push-button start.
●
If the electronic key is inside the vehicle
and a door handle becomes wet during a
car wash, a message may be shown on
the multi-information display and a
buzzer will sound outside the vehicle. To
turn off the alarm, lock all the doors.
●
The lock sensor may not work properly if
it comes into contact with ice, snow, mud.
Clean the lock sensor and attempt to
operate it again.
A sudden approach to the effective
●
range or door handle may prevent the
doors from being unlocked. In this case,
return the door handle to the original
position and check that the doors unlock
before pulling the door handle again.
●
If there is another electronic key in the
detection area, it may take slightly longer
to unlock the doors after the door handle
is gripped.
When the vehicle is not driven for
■
extended periods
●
To prevent theft of the vehicle, do not
leave the electronic key within 6 ft. (2 m)
of the vehicle.
The smart access system with push-but-
●
ton start can be deactivated in advance.
Setting the electronic key to battery-sav-
●
ing mode helps to reduce key battery
depletion.
To operate the system properly
■
Make sure to carry the electronic key when
operating the system. Do not get the elec-
tronic key too close to the vehicle when
operating the system from the outside of the
vehicle.
Depending on the position and holding
condition of the electronic key, the key may
not be detected correctly and the system
may not operate properly. (The alarm may
go off accidentally, or the door lock preven-
tion may not operate.)
Customization
■
Some functions can be customized.
1-6. Entering/exiting the vehicle
(P.583)
87
1
Advertisement
Table of Contents
