Table of Contents
Advertisement
52
1-3. Charging with the EV system
release button is pressed and held for sev-
eral seconds during charging. When
restarting charging, reinsert the charging
connector after pulling it out, and check
that the charging indicator of the charging
port illuminates.
■
Charging time may increase
P.48
■
When your circuit breaker trips during
charging
The upper limit of the charging current can
be changed on the center display as fol-
*1, 2
lows.
(P.597)
Max
●
●
16A
8A
●
The maximum charging current is limited to
less than or equal to the selected current.
If the breaker still trips while charging, even
after changing the upper limit of the
charging current, check if the connected
power source meets the specified charging
conditions. (P.41)
*1
: The maximum charging current cannot
be changed when the power switch is in
ACC.
*2
: If the power supply of the AC charging
stand being used has been adjusted or
depending on the AC charging cable
being used, the supplied current may be
lower than the set maximum charging
current.
*3
: Restricting the charging current will
lengthen the charging time.
■
Changing the "Charging Limit" settings
The upper limit of the charge capacity can
be changed on the center display as fol-
*
lows.
(P.597)
Full
●
●
90%
80%
●
●
70%
60%
●
50%
●
The selected upper limit value is common to
AC charging and DC charging.
If the setting is changed during DC
charging, charging may stop due to the
operation of the DC charger timer and the
traction battery cannot be fully charged.
*
: The charging limit settings cannot be
changed when the power switch is in
ACC.
■
Protection function of AC charging inlet
overheating
By installing a temperature sensor to the
AC charging inlet, prevents parts from
melting when the temperature rises due to
foreign matter entering the charging con-
nector.
When a certain temperature increase is
*3
detected, charging is stopped immediately.
After this, when a door is opened while the
power switch is off, a message will be dis-
played on the multi-information display
(P.483)
WARNING
■
When charging
Observe the following precautions.
Failure to do so may cause an unex-
pected accident, resulting in death or
serious injury.
●
Connect to a power source suitable
for charging. (
●
Check that the AC charging cable,
plug and socket are free of foreign
matter.
●
Before charging, check that the AC
charging inlet is not deformed, dam-
aged or corroded, and check that the
inlet is free of foreign matter such as
dirt, snow and ice.
If there is dirt or dust in these areas,
remove completely before inserting
the charging connector.
P.41)
Advertisement
Table of Contents
