Table of Contents
Advertisement
turned to ON with the DC charging con-
nector connected, the charging cable indi-
cator turns on to notify that the DC
charging connector is connected.
■
Charging time may increase when
P.48
■
When the DC charging connector can-
not be inserted into the DC charging
inlet
P.40
■
If a message indicating vehicle error on
the DC charger side is displayed
Even if a message indicating vehicle error
on the DC charger side (ex. vehicle error
found, vehicle error occurred, etc.) is dis-
played, there is no vehicle fault but possibly
a communication error between the DC
charger and vehicle. In this case, there may
be terminal damage (bad contact) in the
DC charging connector. If there is no error
with the vehicle, contact the facility man-
ager of the DC charger.
During DC charging
■
●
The current charging condition can be
checked on the multi-information display.
The actual charging time may differ from
●
that displayed on the DC charger during
charging.
●
There may be occasions the radio cannot
be heard due to noise occurrence during
DC charging
●
As the battery approaches full charge,
the charging speed will decrease and it
will take longer to complete charging.
The time to complete charging may
●
change, or charging may stop before
reaching the upper limit of the charge
capacity, due to the remaining charge of
the traction battery, the outside tempera-
ture, the specifications of the charger
1-3. Charging with the EV system
(stand), etc.
●
It is recommended to avoid frequent DC
charging to prevent a decline in the trac-
tion battery capacity.
●
Quickly move from the DC charging
space for other users after the DC
charging is completed.
Depending on the specifications of DC
●
charger used, charging may be stopped
before fully charged.
●
If DC charging is performed while the
traction battery is extremely cold, such as
in cold weather, steam may come out of
the motor compartment or dew may be
formed on the hood. This is because the
heat, generated while the traction battery
is warmed, causes snow, ice, or frost to
evaporate. This is not a malfunction.
How to set the DC charging power
■
You can change the DC charging power
limit on the center display.
*
: The settings cannot be changed when
the power switch is in ACC.
●
Max
125kW
●
●
100kW
●
75kW
50kW
●
The maximum power when charging is lim-
ited to the selected power or less.
If Max is selected, the vehicle will be
charged with the maximum power that can
be charged.
■
Changing the "Charging Limit" settings
P.52
■
If "Check Charging System Close
Charging Port Lid See Owner's Man-
ual" is displayed on the multi-informa-
tion display
P.492
57
1
*
(P.597)
Advertisement
Table of Contents
