Table of Contents
Advertisement
Changing to the low beams
1
Press the Adaptive High-beam Sys-
tem switch.
The AHS indicator will turn off.
Press the switch to enable the Adaptive
High-beam System again.
Temporarily changing to the low
beams
It is recommended to switch to the low
beams when use of the high beams is
inappropriate or when the high beams
may cause problems or distress to
other drivers or pedestrians nearby.
1
Pull the lever rearward and then
return it to its original position.
The high beams will illuminate while the
lever is pulled, however, after the lever
is returned to its original position, the
low beams will remain on for a certain
3-1. Driving when the surrounding area is dark
amount of time. After this, the Adaptive
High-beam System will operate.
AHB (Automatic High Beam) (if
equipped)
The Automatic High Beam uses a
front camera located on the upper
portion of the windshield to detect
the brightness of the lights of vehi-
cles ahead, streetlights, etc., and
automatically changes the head
lights between the high beams and
low beams.
WARNING
For safe use
■
Do not overly rely on the Automatic High
Beam. Always drive safely, taking care to
observe your surroundings and turning
the high beams on or off manually if nec-
essary.
■
To prevent unintentional operation of
the Automatic High Beam System
When it is necessary to disable the sys-
tem: P.269
Using the Automatic High Beam
system
1
Press the Automatic High Beam
switch.
171
3
Advertisement
Table of Contents
