Table of Contents
Advertisement
452
8-5. Tire maintenance
ID codes will be registered to the displayed
wheel set.
To change the wheel set to be registered,
select the displayed set, and then select the
wheel set you wish to register.
If ID codes have already been registered
for that wheel set, the tire pressure warning
light will slowly blink 3 times, and a mes-
sage indicating that change is occurring
will be displayed on the multi-information
display.
7
Select "New tire registration".
8
Select "Continue".
The tire pressure warning light will slowly
blink 3 times and a message indicating that
ID code registration is being performed
will be displayed on the multi-information
display. Wheel set changing will be can-
celed and registration will begin.
When registration is being performed, the
tire pressure warning light will blink for
approximately 1 minute then illuminate and
"---" will be displayed for the inflation pres-
sure of each tire on the multi-information
display.
If the tire pressure warning light does not
blink 3 times when starting ID code regis-
tration procedure, the procedure may not
have started. Perform the procedure again
from the beginning.
9
Drive straight (with occasional left
and right turns) at approximately
25 mph (40 km/h) or more for
approximately 10 to 30 minutes.
When registration is complete, the tire
pressure warning light will turn off and a
message indicating that registration has
been completed will be displayed on the
multi-information display.
Registration may take longer than normal
to complete if the vehicle speed cannot be
maintained at approximately 25 mph (40
km/h) or more. If registration cannot be
completed after driving for 1 hour or more,
perform the registration procedure again
from the beginning.
■
When registering ID codes
Normally, wheel position registration can
●
be completed within approximately 30
minutes.
●
ID code registration is performed while
driving at a vehicle speed of approxi-
mately 25 mph (40 km/h) or more.
If ID codes are not registered easily
■
In the following situations, ID code regis-
●
tration may take longer than usual to be
completed or may not be possible.
• When the vehicle has not been parked
for approximately 15 minutes or more
before being driven
• Vehicle is not driven at approximately 25
mph (40 km/h) or more
• Vehicle is driven on unpaved roads
• Vehicle is driven near other vehicles and
system cannot recognize tire pressure
warning valve and transmitters of your
vehicle over those of other vehicles
• Wheel with tire pressure warning valve
and transmitter installed is inside or near
the vehicle
●
If the vehicle is reversed during registra-
tion, all data collected until then will be
cleared. Perform driving again.
If registration does not complete after
●
Advertisement
Table of Contents
