Checking Tire Inflation Pressure - Lexus RZ450E 2023 Owner's Manual

454
8-5. Tire maintenance
each tire on the multi-information display.
After approximately 2 minutes, the wheel
set change will complete, the tire pressure
warning light will turn off, and a completion
message will be displayed on the
multi-information display.
If changing does not complete after
approximately 4 minutes, a message indi-
cating that the change could not be com-
pleted will be displayed.
Check which wheel set is installed and per-
form the change procedure again from the
beginning.
7 If the specified tire inflation pres-
sure of the wheel set installed dif-
fers from that of the previous set, it
will be necessary to perform the
tire inflation pressure setting proce-
dure of the tire pressure warning
system. (P.449)
If the specified tire inflation pressure is the
same, it will not be necessary to perform
the tire inflation pressure setting proce-
dure.
8
Register the position of each wheel.
(P.448)
Checking tire inflation pres-
sure
You should check tire inflation pres-
sure every two weeks, or at least
once a month. Do not forget to
check the spare.
WARNING
In order to ensure the performance of
the tires, maintain proper tire inflation
pressure.
If the tires are not properly inflated, the
following may occur:
● Excessive wear
Uneven wear
●
Poor handling
●
● Possibility of blowouts resulting from
overheated tires
● Air leaking from between tire and
wheel
● Wheel deformation and/or tire dam-
age
Greater possibility of tire damage
●
while driving (due to road hazards,
expansion joints, sharp edges in the
road, etc.)
NOTICE
After inspecting and adjusting tire infla-
tion pressure, make sure to install the tire
valve caps.
If a valve cap is not installed, dirt or mois-
ture may get into the valve and cause an
air leak, resulting in decreased tire infla-
tion pressure.
Driving with incorrect tire inflation
pressure may result in the following:
 Reduced electricity consumption