Table of Contents
Advertisement
WARNING
When a booster seat is installed,
●
always ensure that the shoulder belt is
positioned across the center of the
child's shoulder. The belt should be
kept away from the child's neck, but
not so that it could fall off the child's
shoulder.
●
Follow all installation instructions pro-
vided by the child restraint system
manufacturer.
●
When securing some types of child
restraint systems in rear seats, it may
not be possible to properly use the
seat belts in positions next to the child
restraint without interfering with it or
affecting seat belt effectiveness. Be
sure your seat belt fits snugly across
your shoulder and low on your hips. If it
does not, or if it interferes with the
child restraint, move to a different posi-
tion. Failure to do so may result in
death or serious injury.
●
When installing a child restraint system
in the rear center seat, adjust both seat
cushions to the same position and
align both seatbacks at the same
angle. The seatbacks must be adjusted
to the same angle. Otherwise, the
child restraint system cannot be
securely restrained and this may cause
death or serious injuries in the event of
sudden braking, sudden swerving or
an accident.
If the seat is adjusted, reconfirm the
●
security of the child restraint system.
When installing a booster seat
■
To prevent the belt from going into ALR
lock mode, do not fully extend the shoul-
der belt. ALR mode causes the belt to
tighten only. This could cause injury or
discomfort to the child. (
1-5. For safe driving with children on board
■
Do not use a seat belt extender
If a seat belt extender is used when
installing a child restraint system, the seat
belt will not securely hold the child
restraint system, which could cause
death or serious injury to the child or
other passengers in the event of sudden
braking, sudden swerving or an accident.
Child restraint system fixed with
a child restraint LATCH anchor
Child restraint LATCH anchors
■
LATCH anchors are provided for the
outboard rear seats. (Tags displaying
the location of the anchors are
attached to the seats.)
When installing in the rear out-
■
board seats
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
1
Adjust the seat.
If there is a gap between the child seat and
the seatback, adjust the seatback angle
until good contact is achieved.
P.125)
2
Remove the head restraint if it inter-
feres with your child restraint sys-
tem. (P.121)
If the head restraint cannot be removed,
77
1
Advertisement
Table of Contents
